Ford E-150 Van
Ford F-150
Ford Ranger XL
Temperature

Where is the temperature sending unit on a E150 1991 351CI engine?

606162

Top Answer
User Avatar
Wiki User
2006-10-28 15:25:47
2006-10-28 15:25:47

Which temperature sensor? There is an air-fuel charge sensor, and a coolant temp sensor.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

should be close to your thermastate. Follow upper hose from radiator to your engine. Should take you right to it.

User Avatar

In the M20 engine it's located on the thermostat houseing, on the M50 it's on the the front of the head intake side.

User Avatar

One scenario could be that the sending unit for the gauge on the engine is bad. Try to locate it and replace it if it is corroded and check the wiring to it also.

User Avatar

It is screewed into the drivers side head between the first 2 spark plugs.

User Avatar

It is on the back of the engine, just behind the distributor.

User Avatar

Engine seal? Valve cover? Oil pressure sending unit?

User Avatar

yes it has both. at least in my 1991 ford ranger does

User Avatar

The 1991 Chevrolet S 10 pickup truck oil sending unit is located on the bottom of the engine, in the oil pan. You will need to remove the oil pan in order to access the oil sending unit.

User Avatar

check the coolant temperature sending unit on a V8 it is in the front of the intake manifold

User Avatar

UNDER HOOD, CENTER, FRONT ENGINE AREA, FRONT DRIVER SIDE OF ENGINE, MOUNTED IN ENGINE BLOCK

User Avatar

Most 1991 sending units on a 1991 Le Sabre screw in. The exact location for the sending unit will depend on which one needs changing.

User Avatar

On a 1991 Ford Explorer , 4.0 litre , OHV , V6 engine : I believe the oil pressure sending unit is on the drivers side of the engine , below the power steering pump

User Avatar

How can I check the ENGINE COOLANT TEMPERATURE (ECT) sensor on my 1991 HONDA PRELUDE SI 2.1L

User Avatar

When a check engine light appears on a 1991 Honda Accord the ECU is letting the driver know the engine is sending an error signal. Sourcing out the problem through a diagnostics test will help narrow what could be something as simple as a blown fuse to something as terrible as a blown engine.

User Avatar

On the side of the Thermostat Housing Depending on engine, for 2.5L its on the side, near the thermostat housing.

User Avatar

driver side above the oil filter> its a long sensor that screws into the engine block

User Avatar

If it has a 4.3L engine the temp sensor is located next to the thermostat housing.

User Avatar

On the 4.0 L - OHV - V6 engine , the oil pressure sending unit is on the drivers side of the engine below the power steering pump

User Avatar

I believe it is on the drivers side of your 4.0 L OHV engine , below the power steering pump

User Avatar

it is located on the firewall side of the engine to the left of the oil filter

User Avatar

Do you mean the Temp sending unit, oil pressure sending unit, or fuel level sending unit?

User Avatar

The 1991 Mercury Capri engine is not an interference engine


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.