0
What else can I help you with?
Where is the coolant temperature sensor on a 1991 12 valve cummins?
On a 1991 12-valve Cummins engine, the coolant temperature sensor is located on the engine block, near the thermostat housing. It is typically found on the driver's side of the engine, towards the rear, and is screwed into the block. This sensor monitors the engine's coolant temperature and sends the information to the engine control unit or gauge.
Where is the temp gauge go into motor of 1991 silverado 5.7?
In a 1991 Chevrolet Silverado with a 5.7L engine, the temperature gauge sensor is typically located on the engine block, near the thermostat housing. It's often found on the driver's side, threaded into the intake manifold or cylinder head. This sensor sends temperature readings to the gauge on the dashboard, allowing you to monitor the engine's operating temperature. Make sure to consult the vehicle's service manual for the exact location and details.
Does a Ford Ranger have a water temperature sending unit and a sensor?
yes it has both. at least in my 1991 ford ranger does
Where is the water temperature sensor for the gauge cluster located on a 1991 Chevy K1500 305 engine?
There is'nt one on the guage cluster but there is on the motor up by the thermostat housing
What should the mpg be for a 1991 ford ranger with a 4.0 engine?
Check out www.fueleconomy.gov
What is the horsepower of a 1991 Ford Ranger 3.0 liter V6 engine?
145hp
We replace the temperature gauge in my Chevy blazer what should it read for it to not be over heating?
We replaced the temperature gauge in my 1991 Chevy blazer what is the normal operating temp?
What is the correct temperature thermostat for 1991 ford ranger 2.3?
195 degrees F
Why does my 1991 dodge spirit says its over heating when it is not?
My 1992 Spirit does the exact same thing... its either the Coolant Temperature Sensor that screws into the engine or as in my case a faulty Temp Gauge.
Is the oil pressure gauge on a 1991 Mercedes 190E supposed to be pegged at 3 instead of in the middle of the gauge at 1.5?
i have a 1993 190E - my oil pressure gauge always sits on 3. ==New Answer Haedline == The oil pressure gauge actually moves but is related to several factors Engine Temprature Oil viscosity Engine speed. When you start you car the engine temperature is low the gauge goes to 3, after a long drive/travel and if your temp gets to 80C then with an engine speed of 750-800 RPM you oil pressure gauge will read about 1.5. if you rev. the engine the pressure gauge goes up to 3
Your 1991 ford ranger oil pressure gauge doesnt work what could be wrong?
Bad oil pressure sending unit?
Is a 1991 ford 2.3 an interferance engine?
No , the 2.3 liter four cylinder engine used in a 1991 Ford Ranger is NOT an interference engine ( according to the Gates website , they make timing belts etcetera )
