POP THE HOOD IT SHOULD BE RIGHT BEHIND THE TIMING COVER FOLLOW THE TOP RADIATOR HOSE FROM THE RADIATOR TO THE CYLINDER HEAD,TAKE OFF THAT HOUSING AND YOU WILL FIND IT,,,,ALWAYS REPLACE EVERY 15000KMS ALWAYS
92 b2200 ,fuel injection psi should be 38 to 46 psi
This should be located under the left drivers side kick panel.
MY 1992 MAZDA B2200 PICKUP RUNS GREAT FOR A SHORT TIME AND THEN SEEMS TO STARVE ITSELF WHEN I GO TO GIVE IT FUEL ALMOST TO THE POINT WHERE IT WON'T RUN IF I TURN THE ENGINE OFF FOR A FEW SECONDS IT WILL GO GOOD AGAIN BUT ONLY TO REPEAT THE PROBLEM OVER AGAIN
Wish side the thermostat is place it inside
The 1992 Mazda B2200 will hold close to 17 gallons of gas. The 1992 Mazda B2200 is a four-cylinder vehicle.
Look in the removable housing at the engine end of the upper radiator hose
no
The torque specs for the cylinder head on a b2200 are 59-64 ft lbs (cold).
14.8 gallons
.32
behind the radiator,in the middle of the engine
My 89 B2200 does this. Its like there is a dead spot in the acceleration. It is because the accelerator pump is leaking.