on the intake manifold front of motor on top
Should be in housing at the end of upper radiator hose
Follow the upper radiator hose from the radiator towards the engine. The upper radiator hose is connected to the thermostat housing on the engine side. The thermostat is under/inside the thermostat housing. Remove the upper radiator hose from the housing then remove the two bolts holding down the thermostat housing then remove the thermostat housing to expose the thermostat.
remove the thermostat housing bolts 13mm or 14mm (it is atacched to your upper radiator hose) and remove thermostat clean intake surface and housing replace with a new a gasket anf you are done
Drain the radiator into a suitable container. At the end of the upper radiator hose on the engine is the thermostat housing. Remove the 2 bolts and remove the housing. Remove the thermostat and clean both surfaces. Install the new thermostat and the housing. Service the radiator as needed.
you will find it on the motor side of the upper radiator hose remove the housing that connects the hose to the motor and it's rite ther
The thermostat can be found inside of the thermostat housing. The thermostat housing is located on the front of the engine.
1998 Chevrolet Blazer did not have vent windows.
Drain the radiator into a suitable container. Remove the upper radiator hose at the engine. Remove the 2 bolts holding the thermostat housing and remove the thermostat. Clean both surfaces and install the thermostat and gasket. Install the housing and the upper radiator hose. Top off the radiator.
195 degrees Fahrenheit.
The thermostat housing on the 1998 Mazda 626 6 cylinder is located underneath the air filter housing. You need to remove this air filter housing to get to the thermostat housing. There's two (2) bolts the left connecting the thermostat housing to the motor and another two (2) bolts facing the steering wheel connecting it to the engine. This is where the thermostat is housed.
Remove the water supply hose from the thermostat housing. Remove the thermostat housing retaining bolts. The thermostat will lift out. Reverse the process to install the new thermostat.
The thermostat in a 1998 Hyundai Accent is located on the engine block. The thermostat can be found by following the upper radiator hose to the thermostat housing.