The Thermostat Housing is located on the right hand side of the engine. Remember this is FWD configuration so think of it as being mounted on the "rear" of the engine in terms of normal V6, V8, L6, etc. Trace the radiator hose (right side of radiatoras you are looking from the front of the engine) and you will find it leads to the "water outlet" on the thermostat housing. There are a total of 4 hoses attached to the Thermostat Housing. It is a black plastic (OEM) housing held onto the engine by 3 bolts. Note: ther are 3 Torx screws visible, they for the water outlet housing and can be worked on while the Thermostat Housing is off of the engine. Plastic can easily crack/score so be gentle whe removing the hoses and hardware. This housing is notorious for leaking even when a new gasket (O-Ring) is installed. I suggest dressing the housing mount surface with a small bead of grey RTV along with a new gasket prior to installing. Be sure to use only a small bead in an effort not to get excess into the housing or to foul the gasket.
Just follow the top radiator hose to the stat housing, inside the housing is your thermostat...
Yes, but just below the thermostat.
on top of the thermostat housing.
Follow the top radiator hose to where it meets the housing that goes into the driver's side of the engine, the thermostat is in that housing.
Probably in the housing at the engine end of the upper radiator hose
Should be located in a removable housing at the engine end of the upper radiator hose
thermostat on a ford 2002
follow the top radiator hose to the engine, the thermostat is located in the housing that that end of the hose is connected to
Follow the top radiator hose from the Radiator to the engine. The thermostat is locataed under the housing that bolts onto the engine
Water pump maybe?
Follow the upper rad hose to the engine and at the engine there is the thermostat housing. Make sure when replacing the thermostat the spring goes toward the engine.
The Ford puma thermostat housing is on the side of the engine, with two hoses connected to it. Be sure to replace the gasket when installing the housing.