The thermostat is located on the back side of the engine if you are facing the car. As you face the car, it will be to the passenger side, down under the exhaust manifold. To get to the thermostat, you will have to remove several different bolts. Remove the heat shield on top of the exhaust manifold, three bolts there. Under the engine, you wil see a metal pipe that leads up to the thermostat housing that will have a blt with a wiring clp attached to it, remove that. Then there are the two bolts that hold that pipe up that you wil need to remove then. If you need more info, let me know, I just changed mine.
The thermostat on a 2000 Pontiac Grand Am 2.4 liter 4 cylinder is located on the side of the engine. It can be found by following the upper radiator hose.
Assuming you have the 2.2, 4 cylinder engine, the thermostat is located on the side of the engine that faces the firewall.
Assuming you have the 2.2, 4 cylinder engine, the thermostat is located on the side of the engine that faces the firewall.
the top radiator hose and follow it to the engine
The thermostat is located near the intake on a 1999 Pontiac Grand Am GT. The thermostat can be located by following the upper radiator hose directly to the thermostat.
in the water pump
Follow the upper raditor hose from the raditor to the motor, the raditor hose is connected to the thermostat housing, take the houseing off, the thermostat is under the housing.
where is valve cover located on a 2001 Pontiac Grand-Am 4 cyl
under the throttle body
Thermostat housing diagram for a 2000 Pontiac grand am?
The EGR valve is located on the side of the intake on the 2000 Pontiac Grand Am. It is close to the intake manifold.
It is located directly under the throttel body.AnswerWhere is the thermostat on a 2002 Pontiac Grand Am?" Answerwhere is the thermostat on a 2000 Pontiac grand am Instructions on how to change a thermo..Hello, this page has instructions on how to install a new thermostat on a 99+ Grand Am. Also, not listed on the page as an instruction but something I did when changing the thermostat was to take off the throttle body which made getting to the inlet manifold bolts much easier. The bottom bolt was particulary hard to get too, the top bolt was not too bad. Good Luck. http://www.grandamgt.com/thermostat-pfyc.HTML