0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace front wheel bearings on a Nissan Pulsar N15?
how do you replace rear wheel bearings on nissan pulsar
How do you change the power steering belt on a n15 Nissan Pulsar?
The power steering belt on the n15 Nissan Pulsar is located between the passenger cab and the engine. This is a difficult area to work on at home. It may be best to see a professional as exposure of the area is difficult to achieve.
How to adjust timing on pular srv n15?
how to set timing on nissan pulsar srv
Where is the engine number of a 1996 Nissan Pulsar N15 located?
On the engine block behind the radiator. If the car is AT then just behind the ATF check stick. Byron
Why is my Nissan pulsar n15 stalling?
maybe ur clutch is worn out, what exactly happens when u try go?
How do you change wheel bearing on a N15 Nissan Pulsar back left?
take it to an auto repair shop .or buy another car .or not.
Where is the thermostat on an N15 Pulsar?
At the right hand side of the block (viewed from the drivers' seat) just beneath the brake master cylinder. A bit of a fiddle to get it out! Regards, Alistair.
What oil type for 98 Nissan Pulsar n15?
In a 1997 N15 Pulsar with the GA15DE engine, I use a 10w40 synthetic oil (Castrol Magnatec) recommended by the local store. To find the right oil you can go to: http://www.datateck.com.au/lube/castr_nz/default.asp Just enter info on your car and it will say what oil is recommended.
How do you disable central locking on a Nissan Pulsar N15 series?
i was able to do this by going to the fuse box under the bonnet and removing the power windows fuse, 25A 32v
Where is the blower fan resistor on N15 Pulsar?
the Blower Motor Resister is located under the Glove Box. its connected to the Motor with two scrows one on each side. dont forget to unplug it. when its out it looks like a card.
How do you replace the front wheel bearing in a N15 pulsar?
about 2-3 hrs of work maybe blood sweat and tears ... Make sure to get a wheel Alignment afterwards
Keyless remote on n15 Nissan Pulsar help?
Get into car and close the doorsInsert key and turn ignition from off to ACC and back off five timesOn fifth turn, the hazard lights will flash onceTurn ignition OFFPress button on the remote controlHazard lights will flashRemove the key and test that the remote locks
