Want this question answered?
It is located on the transfer case this is the motor that shifts your four wheel drive
Fill plug is located on the center rear of the transfer case
The slip yoke on the Ford Bronco is located on the rear axle rather than on the transfer case. This is the portion of the axle that allows it to flex.
no
Yes it should . There is only 2 different ones. It is easy to read the tags. I forget the exact but -----54 or 58. Before you get to durty.
Fill plug is located on the center rear of the transfer case.Fill plug is located on the center rear of the transfer case.
Drop the driveshafts. Remove the transfer case with a transmission jack. it's heavy. Be careful. have fun realigning the spud shaft when replacing.
it took me about an hour on my 87 bronco2
its the borg warner 1350
It is next to the transfer case solonoid located underneath the damp control spectrometer.
Are you talking about the speedometer gear?? If so it will be located on the transfer case towards the rear on the drivers side.. It is black and sticks out about 3" with the speedo wire coming out of it.. There is a 10 or 11mm bolt holding it on.. Cheers Mike
I am not 100% sure what the question is, but here is a shot at it. If you are trying to replace the u-joint, there is a video at myjeepwrangler.com under Fix-it > u-joint