On the automatic trans, you will have to remove the pan to drain.
On the automatic trans, you will have to remove the pan to drain.
It is bolted to the driver side of the engine.
A Plymouth Breeze uses ATF+4.
41TE
What kind of trassmission for 1998 Plymouth breez
Front, back, and transmission side of the block.Front, back, and transmission side of the block.
The neutral switch on a 2000 Plymouth Breeze is typically located on the transmission. It is usually mounted on the side of the transmission case and is connected to the transmission linkage. This switch helps ensure that the vehicle can only be started when it is in the "Park" or "Neutral" positions. Always consult the vehicle's service manual for precise location and troubleshooting steps.
The transmission input sensor on a 1996 Plymouth Breeze is typically located on the transmission case, often near the bell housing where the transmission meets the engine. It monitors the input shaft speed and relays this information to the engine control unit. For precise identification, it's advisable to refer to a repair manual specific to the vehicle or consult a professional mechanic.
The transmission uses ATF+4.
On a 1998 Plymouth Breeze, the starter is located on the driver's side of the engine, near the transmission. It is positioned towards the bottom of the engine, making it somewhat difficult to access without raising the vehicle. You'll typically find it mounted to the engine block, just above the transmission bell housing.
Very. not a diy job
add gasoline dumbo
On a Plymouth Breeze, the torque converter clutch (TCC) wire connector is typically located near the transmission, often on the driver's side. It can be found connected to the transmission harness, close to the transmission case or near the front of the transmission where the torque converter is situated. For precise location, it's advisable to consult the vehicle's service manual or a repair guide.