0
What else can I help you with?
Where is the transmission fluid drainage located on a 1998 Plymouth breeze?
On the automatic trans, you will have to remove the pan to drain.On the automatic trans, you will have to remove the pan to drain.
How do you get to the Fuel Pump on a 2000 Plymouth breeze?
You have to remove the fuel tank.You have to remove the fuel tank.
Where is starter located on 99 Plymouth breeze?
The starter on a 1999 Plymouth Breeze is located on the driver's side of the engine, near the transmission. It is positioned towards the lower rear part of the engine block, making it somewhat challenging to access. To reach it, you may need to remove some components or gain access from underneath the vehicle.
How do you replace a washer pump in a Plymouth Breeze?
Remove the reservoir, remove the old pump and install the new one.
Where is crankshaft sensor located on 1996 Plymouth breeze?
On a 1996 Plymouth Breeze, the crankshaft sensor can be found above the oil filter. It should be accessible without having to remove any other parts.
How do you remove the left front drive axle from a 1999 plymouth breeze?
To remove the left front drive axle from a 1999 Plymouth Breeze, first, lift the vehicle and secure it on jack stands. Remove the wheel and brake components, then detach the lower ball joint and the axle nut. Next, pull the drive axle out of the transmission, ensuring to catch any fluid that may leak. Finally, you can replace the axle by reversing the process.
How do you change the battery on a 1999 Plymouth breeze?
You have to remove the drive side tire and the wheel cover to get to the battery.
How do you replace the water pump on a 1997 Plymouth Breeze?
You must remove the timing belt to get to water pump.
How do you remove thumb twist screw to get to the battery on a Plymouth Breeze?
Push up on it turn ninety degrees and pull.
How do you remove a starter from a 1999 Plymouth Breeze?
Disconnect - battery terminal Raise and support vehicle Remove wiring harness from starter Remove mounting bolts Drop starter
How do you remove drive axle from a 1999 plymouth breeze?
To remove the drive axle from a 1999 Plymouth Breeze, first, ensure the vehicle is securely raised and supported. Remove the wheel and brake components, then detach the lower control arm and any other necessary suspension parts to gain access. Use a pry bar to pop the axle out of the hub assembly and then carefully pull the axle out from the transmission, taking care not to damage any seals in the process. Finally, inspect and replace any worn parts before reassembling.
How do you remove and replace the oil pan on a 1997 Plymouth Breeze?
OIL PAN REMOVAL Drain engine oil. Support Engine Remove transmission bending bracket. Remove front engine mount and bracket. Remove transmission inspection cover. If equipped with air conditioning remove oil filter and adaptor. Remove oil pan bolts. Remove oil pan. Note: If the exaust blocks oil pan removal, you'll need to loosen it at the manifold also.
