307 2.0ltr Hdi 110. Behind the engine above the rear gearbox mount and osf driveshaft intermediate bearing block. It is possible to remove from below but is not easy. Owing to 1. Off side drive shaft removal 2. Cat and DPF removal 3. Battery removal, to gain access to gearbox mount to lower engine to remove steady and brackets. 4. Remove top and bottom turbo stays 5. Remove oil feed (be careful not to lose the small filter in the pipe) and return pipes. 6. Remove three 11mm turbo nuts 7. Pull bottom of engine forward this give just enough room to remove turbo. Owing to the careful selection of bolt that are too long, battery tray secured by all bolts from engine compartment except one from under n/s inner wing. It is a vert time consuming job. Took two days. I hope this helps
307 2.0 hdi oil filler cap
H.D.I stands for High Direct Injection, a bit like a turbo i suppose.....
hallo how need replace alternator belt and tensionier on peugeot 307 hdi manual?thanks
5w40
how to remove starter motor for Peugeot 206 1.4 hdi.
Timing belt interval on a peugeot 307 1.6 hdi 110 2004 every 20,000 miles.
I have a 307 HDI 2.0. I checked with the local Peugeot garage and they looked it up for me. You shouldn't need to change the belt until you've done up to 96,000 miles.
on the wind screen.
There are a few places where one may purchase a Peugeot 307 HDI online. This includes using website such as eBay as well as auto sites such as AutoTrader.
Labour £200 to £250
how to change a air filter on a 307 sw
how do u change the timing belt in my 307