Want this question answered?
It shoud be located on the transmission.
yes but be careful
Your Vehicle has two oxygen sensors. The upstream or pre-cat sensor is located in the exhaust manifold, under the hood , towards the rear of the vehicle. The downstream or post-cat sensor is located in the exhaust pipe, after the cat, under the vehicle.
A 1993 Jeep Grand Cherokee does not have a speedometer cable. The speedometer signal comes from a sensor on the transmission or transfer case.
The output speed sensor on the transmission is also the vehicle speed sensor. The output sensor is the two wire sensor on the front of the trans all the way to the driver side.
Your vehicle used the OBDII computerized system, Look here for the codes and their meanings.What_are_the_different_OBDII_trouble_codes_and_their_meanings
Mounted atop the transmission tail shaft.
were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine
The sensor is located at the lower center of the engine block back side. Has a plug with two wires that attaches to the sensor. One 8mm bolt holding the sensor on place. You will have to be under the vehicle to see the sensor location on the rear of the engine.
Assuming that the vehicle is front wheel drive, you have four abs sensors, one behind each wheel.
sensor is located on coolant housing at engine front
It does not have a mass airflow sensor.