0
The vent is located towards the front of the tranny on the drivers side just above the fluid pan mount. daner@copper.net
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
If you overfill a 1976 350 turbo trans will it leak out the rear of the trans by the front U joint Its not leaking out of the seal?
The yoke on the driveshaft of a gm turbo 350 trans has a small vent hole in it. If the trans is over filled to the point fluid comes out of it you will do serious damage to the trans if you try to drive the vehicle.
What is the difference in a TH 350 and 350 turbo trans?
None, TH stands for turbo-hydromatic, hence th350 or 350 turbo.
How do you get the tail shaft out of 350 turbo trans. how do you get it out?
c4
What size transmission is in a 1983 El Camino with a 305?
Probably a turbo 350 trans. This is a three speed trans. The way for you to check is to look at the trans pan. look up a picture of a turbo 350 trans and compare it to your trans pan.
Will a 350 turbo trans bolt up to a 4x4 pickup?
Yes, there are 350 turbo transmissions that will bolt up to a 4x4.
Dose the breather vent have to be hooked up on a 350 turbo trans?
breather vent on top of tyranny is open to air the only vacuum hose that's hooked up is shift modulator to constant vacuum on manifold
What is the Spline count output shaft turbo 350 trans?
27
Where is the front seal located in the turbo 350 transmission?
It is located at the front of the transmission, on the pump. You can see it on the pump were the torq converter goes into the transmission. The trans has to be pulled out of the car to do the repair.
Will a turbo 350 trans bolt up to a 6.0 liter motor?
NO it will not. Not even close.
Can you use a flywheel with a turbo 350 trans?
You would need a ring gear for an automatic.
What transmission would be in a 1978 trans am with an L78 400 motor?
350 turbo automatic
Is a 350 turbo transmission better than a stock 350 transmission?
One and the same. The GM name for that trans is turbohydramatic.
