most washer fluid pumps are on the resivour itself
How to check the transmission fluid in a 1995 Mazda 626
To replace the windshield washer pump on a 1993 Mazda 626 DX, first, disconnect the negative battery terminal to ensure safety. Then, remove the washer reservoir by unscrewing any fasteners and disconnecting the hoses. Take out the old pump from the reservoir, install the new pump, and reconnect the hoses and electrical connector. Finally, reassemble the reservoir and test the pump to ensure it’s functioning properly.
The reservoir is located on the master cylinder in a Mazda 626. To add fluid, simply remove the reservoir cap and pour fluid in.
The brake fluid reservoir on a 1989 Mazda 626 is on the master cylinder. This is located in the engine compartment on the drivers side.
on a Mazda 626 there is a fuel pump relay check to see if you have a power signal from the relay to the pump, if so make sure there is power to the pump.
On a 1997 Mazda 626 4-cyl, the (electric) fuel pump is located inside the gas tank.
The water pump from Mazda 626 is the same, all part from Mazda 626 work very good in the Kia Credos and Clarus.
There is none.
in the gas tank
The 1995 Mazda 626 fuel pump relay switch can be found attached to the frame, next to the gas tank. The relay switch should be labeled as such.
The fuel pump relay on a 2002 Mazda 626 is located in the engine compartment on the driver's side. It is in a bank of relays just behind the battery location.
Dextron III or IV