It is behind the timing case cover behind the crankshaft pulley.You have to remove the timing belt to replace the water pump for this repair.
where is the water pump located in Mazda millenia
The most likely cause is a blown head gasket.
behind the radiator,in the middle of the engine
Try the bottom of the radiater on the driver's side, should be a plastic plug. If not, you may have to remove the water hose to drain. If the plug is there, it may be very small, and hard to see.
On four cylinder models, the water pump will be attached to the timing cover on the front-side of the engine. Typically behind the fan clutch and pulley. On six cylinder models, the water pump is typically in a similar location, but additional accessories may need to be removed to access it.
on the front of the engine behind water pump (water pump is bolted to it )
the cluth fan bolts right up to the water pump mounted on the block
JUST FOLLOW THE FAN BLADE AND YOU WILL FIND IT ON THE FRONT OF THE MOTOR
Most likely water or debris in your fuel tank!!!
if its a305,or 350 it is located intake by the thermostat housing.or in the t-stat housing
It is at the lower end of the top radiator hose within the water outlet on the motor.
Follow the top radiator hose down to the water outlet on the engine; it is in the water outlet. Mark