answersLogoWhite

0

The water pump on a 1997 Honda Accord is attached to the 2.2 VTEC motor. The water pump is located underneath the pulleys of the drive belt of the motor.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you change water pump 1997 vw jetta gl?

Which motor? 1.8 1.9 2.0 2.8?


Where is the water pump on a 1997 Cadillac eldorado located?

it is on the drivers side of the engine compartment in the front of the motor when you start the motor you will see a small belt turnig and you will need a specail tool to get the water pump out


What is the mechanism inside the motor which you used to pump water?

Water pumpWater pump


How to replace a water pump on a 1997 Honda Accord?

where is the water pump located on 1997 honda accord


How do you install a water pump in a 1997 Oldsmobile aurora?

remove and replace water pump in 1997 Oldsmobile aurora


How do you change the water pump on a 1997 Chevy Malibu V6?

How do you change the water pump on a 1997 chevy malibu?


1997 dodge avenger with water leak on front of motor cant tell where its coming from any ideas?

If your talking about front of the motor (passenger side) its most likely the water pump seal. Hope this helps.


Where is distributor cap on a 1997 z28 Camero with the lt1 motor?

it is behind the water pump in front of timing chain cover driven by cam


What is an Impeller pump on motor vehicle engine?

The impeller pump on a motor vehicle is more commonly know as the water pump. The water pump, pumps water through your cooling system to keep your vehicle from running hot.


Where is the water pump located at on 2001 neon?

the water pump is run by the timing belt the water pump is where the timing belt at in the motor


How do you replace the water pump on a 1997 Dodge Intrepid?

If you have a 3.5 liter motor, take it to an independent shop, I would not recommend it for d-i-y ers.


How do you replace water pump on a 1997 mercury villager?

You will need to drain the water from your 1997 Mercury Villager cooling system. Remove the water pump belt. Remove the water pump hose. Remove the water pump retaining bolts. Reverse the process to install the new water pump.