Want this question answered?
where is the water temperature sender unit on a ford puma
Where is the water temperature sender 1995 ford ranger 2.3?In: Ford [ranger]
located on left side of water pump
follow the top radiator hose to the engine block. the temperature SENSOR has two wires. The temperature SENDER has one wire
There are two, one which feeds the PCM in the water pump, another for the guage in the drivers's side of the block just below the plugs.
The oil pressure switch is near the oil filter and the water temperature sender is located near the thermostat housing. The fuel sending is in the fuel tank mounted on the fuel pump module.
1,ooo,000,000,
Is located in side right under manifold
in the water pump
on the front of the engine
The temperature sender for the coolant is located in the water outlet. The upper radiator hose goes to the water outlet. The sensor with 2 wires goes to the gauge and the sensor with 3 wires goes to the computer.
Thermostat is the part which functions to maintain engine coolant temperature by restricting the flow ( open and close based on the coolant temperature ) to the heat exchanger ( radiator). Water temperature sender ( water temperature transducer ) is the one which signals the the water temperature gauge. so water temperature sender may not work and show the same value on the gauge. but engine temperature will rise and vary depending on the load. the engine will be cold when you start the engine after an overnight and if you touch some safe parts of the engine you will feel the temperature rise even if the gauge does not indicate it. hope this will help you. thank you.