On a 1973 Pontiac, the water temperature sender is typically located near the thermostat housing or on the engine block. It is usually found on the front of the engine, attached to a water jacket, allowing it to measure the coolant's temperature accurately. Depending on the specific engine model, the exact position may vary slightly, so consulting the vehicle's service manual can provide precise details.
where is the water temperature sender unit on a ford puma
Where is the water temperature sender 1995 ford ranger 2.3?In: Ford [ranger]
located on left side of water pump
follow the top radiator hose to the engine block. the temperature SENSOR has two wires. The temperature SENDER has one wire
There are two, one which feeds the PCM in the water pump, another for the guage in the drivers's side of the block just below the plugs.
1,ooo,000,000,
The oil pressure switch is near the oil filter and the water temperature sender is located near the thermostat housing. The fuel sending is in the fuel tank mounted on the fuel pump module.
Is located in side right under manifold
in the water pump
on the front of the engine
The temperature sender for the coolant is located in the water outlet. The upper radiator hose goes to the water outlet. The sensor with 2 wires goes to the gauge and the sensor with 3 wires goes to the computer.
On the passenger side of engine, on side near back. It's hard to see, and probably the best way to remove is to lay on top of the engine and work blind, by 'feel'. The sender is connected w/ an 'L' shape connector.