On the exterior of the car, right at the bottom of the windshield, there is a air vent running the along the the hood and windshield. you must first remove the wiperblades and then remove the vent, usally with a Philips head screwdriver. You will see the motor in the center of the space attached to the wiperblade arms. Remove the gromet from the arms and remove motor. Replace the motor the same way you took it out. connect arms to motor and put everything back just as you took it apart. Good Luck.
Behind the plastic cover on the wiper motor.
The wiper motor is located under the black plastic cowl below the windshield.
It is attached to the wiper motor.
The motor is located on the passenger side firewall.
Mounts on top of the wiper motor
The wiper motor is located under the cowl, (the black cover in between the hood and windshield) about center of the vehicle.
Inside the wiper motor.
It is attached to the wiper motor. It can be easily changed without removing the wiper motor. Unplug the wire harness to the wiper motor, remove the three small screws holding the cover in place, remove the cover, remove the pulse board.
Remove the wiring harness from the back of your 1994 Chevy Cheyenne wiper motor. Remove the traveling arm linkage. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
Under the hood, on the firewall, drivers side.
The dalay board located on the wiper motor is defective.
The 1988 Jeep windshield wiper motor is located on the firewall in the engine compartment. The wiper motor will be in the center of the firewall.