Want this question answered?
electronic control unit (ecu) that would be the computer for your engine
DC controller
DC Controller
The blower motor control unit is located on the back of the blower motor. 1. Check fuse. 2. Turn on heat and check for voltage at blower motor. Found voltage replace blower. 3. Check for supply power from the fuse on the red wire going to the blower control unit. 4. Check for a good ground on the black wire on the control unit. 5. Check for control power on the yellow wire from the climate control unit. When you select a fan speed (or the unit selects a speed in auto mode) a voltage that ranges from .4 - 9 volts is sent down the yellow wire to the blower motor control unit. 6. If all these checks are good than change the blower motor control unit. Hope this helps.
Shows that there are errors present in the Heating/Cooling control unit.
control unit
It was used to measure the strength of a laser. In the 1960s, razor blades were pretty much similar in shape and a Gillette was a non-standard unit for measuring the strength of a laser beam. The measurement comprised the number of laser blades that a laser device could burn through.
Electronic control unit or computerElectronic control unit or computer
There is no difference.
LSU: Laser Scanning Unit.
The Central Processing Unit (CPU)
None. A laser will control bleeding as it cuts, but that is no different from the cautery unit used in every OR. The cutting lasers are not more precise or selective than a scalpel or a skilled surgeon at the helm of Metzenbaum scissors. Now, non-cutting lasers are a different deal--can be very selective, but are not a scalpel.