In an old-fashioned light bulb, the part that emits light is a resistance. When current flows through it, it heats up so much that it glows - it emits light.
Due to their lousy efficiency, these light bulbs should be discarded, in favor of fluorescent light bulbs or LED light bulbs.
In an old-fashioned light bulb, the part that emits light is a resistance. When current flows through it, it heats up so much that it glows - it emits light.
Due to their lousy efficiency, these light bulbs should be discarded, in favor of fluorescent light bulbs or LED light bulbs.
In an old-fashioned light bulb, the part that emits light is a resistance. When current flows through it, it heats up so much that it glows - it emits light.
Due to their lousy efficiency, these light bulbs should be discarded, in favor of fluorescent light bulbs or LED light bulbs.
In an old-fashioned light bulb, the part that emits light is a resistance. When current flows through it, it heats up so much that it glows - it emits light.
Due to their lousy efficiency, these light bulbs should be discarded, in favor of fluorescent light bulbs or LED light bulbs.
In an old-fashioned light bulb, the part that emits light is a resistance. When current flows through it, it heats up so much that it glows - it emits light.
Due to their lousy efficiency, these light bulbs should be discarded, in favor of fluorescent light bulbs or LED light bulbs.
A light bulb can be part of a circuit.
The function of a light bulb in an electric circuit is that it turns electrical energy into light.
If one light bulb in a series circuit fails, all the other light bulbs will go out, until the failed bulb is replaced and the series circuit is completed again.If one light bulb in a parallel circuit fails, all the other light bulbs will still work.
It completes the circuit!!
it would be ok in a circuit which didn't need a light bulb.
The bulb converts energy from the power source into light and heat. It is the load in the circuit.
A bulb does not light up if there is no voltage available across the bulb, or if the bulb is burned out.
The circuit will have the flow of electricity interrupted.
Make a circuit with 2 wires a batery and a light bulb and touch wire to medle on light bulb
a closed circuit
the circuit which has the maximum power output
When one wire or terminal is not connected to a light bulb, it is not possible for electricity to complete the circuit. When a circuit is not completed, the bulb will not light. An off switch, for example, breaks the circuit.