Want this question answered?
The OBD connector is located behind the ashtray that is loctaed above the center console. Remove the ashtray to make this connector acessible.
Somewhere rear brake light area.
GOOD QUESTION? it's located under the passenger seat there's a small black box with blinking lights to the left of that small light on the unit itself is the connector.
Fuse is blown light connector is unplugged ground wire on trailer disconnected
if it has a connector it will be behind the license plate or you have to install one
The brake light fuse on a 1995 Acura Integra is located inside the cabin of the vehicle. It is on the same circuit as the dash and hazard lights.
Excessive corrosion. Pull harder, Nancy.
they dont have day times....
Fuses are designed and intended to protect the wiring from SHORT CIRCUITS and OVERLOADING. When a fuse "blows" instantly upon connecting the trailer wiring to the vehicle wiring connector,suggests a short in the trailer wiring, or one of the light sockets/fixtures. If the fuse did not blow instantly, but over a period of minutes, would be suggestive ofan overload condition. Sinceit blows the tail light fuse, logic suggests the short should be found in the tail light wires or bulb sockets on the trailer. Another possibility, but very remote, is a defect in one or both of the connector plugs. Look for an area ofcut or chaffed insulation onthe trailer tail light wires, where the wire may be "pinched" in a crevicebetween twometal members of the trailer frame, OR where the wire makes a very sharp turn around a metal edge.j3h. you have a short in the tail light wiring of the trailer
Different brakes and suspension. Towing package may include trailer light connector.
Chances are very good that you have a bad ground wire on your trailer or on the connector. Check the connector for rust or rot, clean the pins and use some grease to prevent future problems. If the problem isn't at the connector, you may have a bad ground on the trailer which could be anything from an ungrounded light socket to a bad ground wire. Hope this helps
The brake light failure sensor on a 1997 Acura 2.2 cl is located on the rear of the car. It is on the back of the left rear lamp assembly.