In the valve body of the transmission. Drain fluid, drop pan, it's located approx looking up while on ur back center front of valve body l. Very small and has. 2 pin connector. To remove push and turn until it twists out. Take causion when I stalling new one not to break tab on sensor. Reinstall filter, pan, and top fluid off. Clear code retest.
How do you change trans. oil in 04 f350? and why does toe keep engageing and stays on
13mm
Impact and wrenches
Trans-Continental Hustle was created on 2010-04-27.
there is a recall on the 04 models. look that up
i HAVE A F350 AN 04 AND MY HUSBAND BOUGHT ME NEW BRIGHT WHITE AND I NEED TO KNOW HOW TO MOVE THEM UP AND ADJUST THE AIM.BEING THAT THERE IS NO HIGH BEAM NOW.THANKS Have your husband get the correct bright white bulbs for you truck and you will have high beams again
just use automatic trans fluid. I think its dextron III. It's the same trans fluid that you'd put in a 04 Xterra trans. --dealership technician
The oil pressure sensor screws into the block. It is mounted close to the oil filter and should be easy to reach.
sticking throttle cable or bad temp sensor
Replacing the gauge could be a costly job but it is seldom the gauge goes bad. More likely the temp gauge sending unit is at fault. Replacing the temp gauge sending unit would take less than 15 minutes.
do not get rpm over 2000I run my 460 between 1500-2000 and I get decent mileage but it tends to make others mad but until they put fuel in my truck they can k m r.
The exhaust back pressure sensor or EBP on the 04 is located by the upper radiator hose by the block. It has a 3 pin connector and accepts a 24mm socket.