0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the year of my 25 hp evinrude 'E25RCNB?
A 25 hp Evinrude, model number E25RCNB, would be a 1982 year model.
What is the weight of evinrude 4hp 4904D?
25
How do you winterize a evinrude 1960 40hp motor?
Look up and see answer entered for "25 hp Evinrude". It is the same.
How much does an evinrude 25 hp boat motor weigh?
I have a 1988 25 hp LS Evinrude pull start and I weighed it at 123 lbs.Retired auto tech
What is the spark plug gap for a 1994 evinrude 25 hp boat motor?
The correct spark plug gap for the 1994 model, 25 hp Evinrude outboard is .030 in.
Evinrude boat motor 25 horse power model E25TECUR serial E0685723?
A 25 hp Evinrude outboard, model number E25TECUR, would be a 1987 year model.
What is the Fuel mixture for 1979 25 hp evinrude?
The 1979 model, 25 hp Evinrude requires a 50:1 ratio, one pint of 2 cycle oil, to six gallons of fuel.
Where can I find an external wiring harness for a 1971 Evinrude 25 hp outboard?
You can find an external wiring harness for a 1971 Evinrude 25 Hp outboard at different boating shops. You can also check with the manufacturer.
How do you determine the age of your 25 hp evinrude and can most be converted from pull to electric start?
The year model for a Evinrude outboard engine is determined from the engine model number. Yes, the 25 hp can be easily converted to electric start.
If wet bulb temperature is 35 and outlet water temperature from cooling tower is 25 then the cooling tower approach will be effective and what is the solution?
The Approach is the difference between wet bulb temperature and outlet water temperature from cooling tower. That means , in this case, Approach = 35-25=10 degrees.
1985 25 hp evinrude spark plug gap?
0.8mm or 0.030 US
Where is the cooling water intake located on a 1971 25 hp evinrude outboard motor?
If you will go to Crowley Marine you can look up just about any old outboard motor. There is a diagram there for the 1971 25 hp Evinrude and if you will look there is a plate on the right side looking at the motor from the propeller end just below where the gearcase extension bolts on. It has several small holes in it and this is the water intake. On the Crowley gearcase drawing it is part #19.
