Want this question answered?
Mounts on top of the wiper motor
chances its not the motor but the wiper module board located on the wiper motor. just remove the wiper motor and the module board is connected to it.
it is located on the front of the wiper motor.
It is attached directly to the wiper motor.
the wiper delay dodule is located under the hood on the firewall. you will see the motor for the wipers and you take that cover off. it has 3 torx bit screws that holds it on. under this cover is a circut board. that is your wiper delay module.
Behind the plastic cover on the wiper motor.
Inside the wiper motor. Easy to change without removing the wiper motor. Unplug the harness connected to the wiper motor, remove the three small screws that hold a black plastic cover on the front of the wiper motor, remove the cover, remove the pulse board. The pulse board is available from your local auto parts store.
It is attached to the wiper motor.
The Ford Explorer was produced from the years 1990 to present. The wiper motor pulse board module in a 1998 Ford Explorer 4.0 L is located on the firewall, behind the engine in the middle.
resistor module is on the right side below the dash next to the heater motor next to the fire wall you will have to remove a kick panel by the glove box
, when you look the motor from the front it is located at your top left on the fire wall Close to the battery Mario
The dalay board located on the wiper motor is defective.