0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
On a 2005 Chevrolet Malibu the instrument lights are not working and the fuses are fine. What could be wrong?
Check the panel lights resistor switch and be sure that they are not turned off.
What ia a reostat switch?
A rheostat is a variable resistor. Examples are a volume control knob or an instrument panel dimmer switch. As the resistance is increased in the switch the volume will lower or the instrument panel lights will dim.
Will a bad heater motor resistor cause your climate control panel not to light up?
No.
How do you replace the blower motor resistor in a 1998 Oldsmobile Intrigue?
On the passenger side under the dashboard, first remove the fire panel and unclip the light. The resistor is towards the far back in the center. There are some screws that are kinda hard to get to, but it is possible. Unclip the wires on the old resistor and remove the screws and remove the resistor. Then place the new resistor where the old one was removed from and replace the screws, attach the wires. Now re-attach the light to the fire panel and replace the panel.
How do you replace the blower switch resistor pack on a 1994 Chevy Caprice?
pull right panel under dash it is held in by clips. directly under the blower panel there are 4 wires together.unclip the wires and there are two screws remove theme and the resistor will come out.
Why wont the panellights come on on a 1984 Chevy s10 pickup truck?
The panel light dimmer switch is turned off. The panel light fuse is blown. The panel light bulbs are blown out.
Where is the door light switch in a 95 Ranger?
it is inside the door panel
Where is the switch for fog light on an A class Mercedes control panel?
PULL the light switch out (must be in lowbeam setting for fog lights to work)
How do you replace the instrument panel lights on a 1999 Toyota corolla?
I doubt that all the lights went out at once so lets start with the light switch. Either the switch or something on the light switch panel turns or slides to control the brightness of you instrument lights. It can also shut them completely off. So try that first. Next xheck the fuse panel for the fuse marked inst panel. It is most certainly one of those two things. If not you can always have the light switch or the instrument panel tested. Good luck.
How can you get your drivers window up when the switch is not working on a 99 Malibu?
Had the same problem my self last week. Take a hot wire and a ground and jump out the switch. Changes are the master switch went bad on the door panel. Ken
How to replace 2006 mustang head light switch?
# Disconnect the negative battery cable # Remove the finish panelfrom the left end of the instrument panel # Reach through the access hole in the left end of the instrument panel end and push out the switch panel from the headlight switch and instrument panel dimmer switch # Disconnect the electrical connectors from the headlight switch and rheost and remove the switch assembly # When installing the switch assembly make sure that it snaps into place in the instrument panel.
Is it still within code to run power from panel to light switch then to light?
You can either go to switch or to light first. I wired house for my brother ran power supply from junction box then to each switch then to light. Passed inspection no problem
