pull right panel under dash it is held in by clips. directly under the blower panel there are 4 wires together.unclip the wires and there are two screws remove theme and the resistor will come out.
where is the switch resistor on 2003 buick
The blower motor speed resistor is burned out. You can replace only the resistor but the resistor probably burned out because the blower motor is going bad. If you want to fix it for good, replace both the blower motor and blower motor speed resistor.
Check to see if you are getting power to blower motor - if so replace blower motor If not check fuse, switch, resistor pack.
It is most likely a bad blower motor resistor. Replace the resistor. If the problem continues, it could be the switch.
replace the blower motor switch
Could be,Blown fuse,Bad blower motor,Bad blower motor switch,Bad blower motor speed resistor,
Defective Blower Motor Resistor Pack. Replace it.
You need to replace the blower motor resistor. I've been there done that.
Most likely your blower motor resistor is bad. I replaced the resistor and the blower motor fan and it ended up being the speed control switch (alot easier to replace than the resisitor). Both the resistor and switch are around $19.
Examine the back of the switch for loose or melted connections. Then examine the resistor for burned spots. In most cases a burned resistor is the result of a failing blower motor. So if a new resistor burns out in a short time, replace the motor also.
To test the blower motor resistor, unplug the resistor connector. Each blower motor switch input terminal on the resistor must have continuity to the resistor output terminal, which is connected to the circuit going to the blower motor. If the blower motor resistor continuity does not check OK, replace the faulty resistor.You need a multimeter to test the resistor block and there should be continuity between all terminals.
Assuming you are asking about the HVAC blower motor, check the condition of the switch and the electrical connection at the switch. And, if the original resistor was burned out the cause is usually because of the blower motor drawing too much current. If so, replace the blower motor or you will burn out another resistor soon.