Want this question answered?
Hydraulic fluid should be poured in the oil tank.
You can add hydraulic fluid to Porsche convertible top motor by popping open your engine hood and then pouring the hydraulic fluid into the appropriate compartment.
Remove the breather cap at rear of tractor, on the left side of the PTO it pulls straight out. It has a dipstick on it. You should be able to add fluid there as well.
under the seat were do you add the hydraulic fluid
In a Ford 4610, you need to add the hydraulic fluid to the rear axle. The Ford 4610 is a 1989 tractor that retailed at close to $19,000.
Look for a hinged panel between the loader uprights. That is where the hydraulic reservoir fill port is located. Lift the hood for better access.
in the back axle
Depends on which machine, I drove many and do remember they all had an easily accessible hydraulic tank.
In the half valve kanooter barring. Unless it is a four barring year 2000-2011, you can put it through the top of the piston.
Should be next to the brake fluid cup. DJ FLIP Housepartykings.com
The hydraulic reservoir on the case 730 should be in about the same area as the case 630......on the right side of the tractor at the rear of the engine and on what would be the bell housing is a large cap screw type plug. There should be a dipstick not too far from it....you add hydraulic oil there, if it is a case-o-matic. If it is a standard transmission, then the dipstick and the plug should be on the rear of the tractor around where the seat bolts on.
The Ford Jubilee has three areas for fluid. The transmission has a filler cap near the gear shift. The hydraulic fluid has a filler cap under the edge of the seat and the differential has a filler cap behind the seat. There is a small dipstick on the right hand side to determine hydraulic fluid level.