Try JC Whitney. Search engine it.
How do you change the spark plugs in 2001 lexus rx300?
Wher are the oxygen sensors located on a 2001 rx300 Lexus SUV
The thermostat on a 2001 Lexus RX300 is replaced by removing the upper radiator hose and unbolting the thermostat housing. The thermostat can then be removed, a new gasket installed, and the replacement thermostat placed in the housing.
In the 2001 Lexus RX300, the starter is located on the driver's side of the engine, near the transmission. It is positioned towards the bottom of the engine bay, making it somewhat difficult to access without lifting the vehicle. To reach it, you may need to remove the air intake assembly or other components for better access.
The AC drain line on a 2001 Lexus RX300 is typically located on the passenger side of the vehicle, near the firewall. It extends from the evaporator case and allows condensation to drain out of the vehicle. You may need to look under the vehicle or the engine compartment to locate it, usually appearing as a small rubber hose. Make sure to check for any blockages if you're experiencing drainage issues.
The lamp out module on a 2001 Lexus RX300 is typically located behind the driver's side dashboard, near the fuse box. To access it, you may need to remove some panels or trim to reach the module. It is responsible for monitoring the vehicle's lighting system and can affect the dashboard warning lights related to exterior lights. If you're having issues with lights, checking this module can be a good troubleshooting step.
Take it out and get a new one!!!!!
The 2001 Lexus coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be in the vicinity of the thermostat housing.
It should be right under the exhaust manifold and in front of the radiator. From the front view its in the middle of the engine.
To replace the EGR valve in a 2001 Lexus RX300, first, disconnect the negative battery cable and remove any components obstructing access to the EGR valve. Disconnect the electrical connector and vacuum lines from the valve, then unbolt it from the intake manifold. Install the new EGR valve, reattach the vacuum lines and electrical connector, and finally, reconnect the battery cable before starting the engine to check for proper operation. Always ensure to clear any diagnostic trouble codes if applicable.
In a 2001 Lexus RX300, each service light on the dashboard indicates different maintenance or operational issues. The "Check Engine" light signals potential engine or emission system problems, while the "Oil Pressure" light indicates low oil pressure, which could suggest a need for oil change or a leak. The "Battery" light warns of charging system issues, and the "Brake" light can indicate a problem with the braking system or that the parking brake is engaged. Always refer to the owner's manual for specific meanings and recommended actions.
All oxygen sensors are in the exhaust. They can either be before or after the catalytic convertor. Just because you have a code for an oxygen sensor does Not mean that it is defective. You can have a vacuum leak causing a lean code. You can also have a leaky injector that will cause a rich code.