I found my replacement light at www.spoilerlights.com.
dealer..
yes it can!! go under your car to wear you see the wires to the light and undo the wires and take the light out then put and wire a new light fixture
If you have a spoiler, its in the middle of the spoiler on the trunk lid. Otherwise it should be in the middle of the back window. If you dont have a spoiler, but have a filler panel between the rear speakers at the rear window glass, I suspect someone has removed the spoiler or replaced the original trunk lid with one without a spoiler.
An additional brake light found most commonly in the rear window or on the rear spoiler of an automobile. These are required by law in some countries.
is it in the rear spoiler? Thru the trunk, light socket is right below rear window
junk yard
In the 997 model the rear spoiler deploys at 75 mph.
There are many different retailers online that can offer you replacement Rear Tail lights or Tail light. check out Www.HIDGuy.net . we offer a lot of replacement LEd tail lights that utilizes a technology that last longer then halogen bulbs.
If one has a rear spoiler on a vehicle the main purpose is to provide better aerodynamics for the vehicle. Many have a rear spoiler simply for styling purposes.
I own a '98 Nissan Altima and couldn't figure it out on my own. It is called a High Mount Stop Light. I looked in the User's Manual and discovered that there is a diagram that illustrates and explains how to do this. Push the light fixture assembly towards the rear of the car and then lift the assembly up. (You may need to push the rear window ledge downward slightly to free the tabs. There are two wires (one Red and one Black) going into the round light socket in the center of the fixture. Turn the socket counter clockwise (I had to use a pair of needle nose pliars, because there wasn't room to get my fingers around the socket). Back the socket out of the fixture, and then pull the light straight out of the socket. Push a replacement bulb straight into the socket. (The manual indicates an 18W bulb type T16.) Leave the light socket, with the new bulb, on the ledge, in plain sight, and then press the brake pedal to make sure the light works before you reconnect the light socket into the fixture. Insert the socket, with the new light bulb, into the fixture. Once in place, turn the light socket clockwise to lock it in place. Realign the light fixture to the openings in the ledge and push down and pull the fixture towards the front of the car.
how do i remove rear spoiler on rx330 2004 model for repainting or recoating clear coat
To change the tail light bulb on a 1986 to 1989 Chevy Celebrity coupe or sedan: 1. In the trunk by the appropriate quarter panel there are three nuts, the middle nut holds the outer end of the tail light fixture in place. Remove that nut, it should align with the middle of the tail light fixture. 2. Pull back on the tail light fixture until the stud comes out of the body. Then pull slightly outward on the tail light fixture to pull a tab out of the backup light fixture. 3. Locate the appropriate socket for the bulb you are going to replace and remove the socket from the tail light fixture. Put in the new bulb and reverse the instructions to put the tail light fixture back in place.