Want this question answered?
In the hydraulic oil tank. Where that's located depends on which model of backhoe you have.
hydraulic oil,AW-300
The primary type of hydraulic oil used in case backhoes is 10wt or AW-46. Each type has specific properties for longevity, performance, and resistance to harsh temperatures.
Left side front hood, unden a lift panel in front of the radiator...
1 - Check the hydraulic pump. Shaft. Rubber gasket. Bearing. 2 - Check the oil pipes. Junction. 3 - Hydraulic cylinder and piston check. Oil leakage. Leverage.
The fuel (typically diesel), coolant, hub oil, lubricating grease, transmission fluid, hydraulic oil. If it has an AC system, you could count the AC refrigerant, as well.
how do I check oil in the rear end of a 3600 ford tractor
Hydraulic fluid is hydraulic oil.... as for the type you use, depends on your system. I used to own two tractor-trailer end dumps, and I actually used ATF rather than hydraulic oil. Check with the OEM for your hydraulic system before you do this, though.
The quick answer is that you simply drain and replace it, but where exactly the drain plug is will depend on the make and model. I could probably answer this question better if I had that information.
Hydraulic oil is very thin and will leak if it gets a chance. It does not burn out but after several hundred hours it may start to disappear Your transmission oil might leak into the engine or the rear end due to bad seals, however you have to determine how much oil you are using over what period of time. you will use some oil thru normal running conditions ,but not very much.
Hydraulic fluid and hydraulic oil are one in the same.
The manual says 8 quarts or 7.6 liters of case TCH fluid ,you can use Hy-tran Ultra hydraulic fluid. I use the hydraulic transmission fluid from tractor supply and have no problems.