Place the first course to overhangs the drip edges by about 1/4 inch and roll it out about 8 feet. At one end, drive nails every 3 inches along with the rake, then pull it taut and drive nails along the eave edge. Nails should be about 1 inch away from the edges.
Rolled roofing isn't nailed at all it's applied with a roofing adhesive.
Galvanized nails are used in roofing they stand up to weather better, no rusting.
Since the die is rolled (or even rooled) only 5 times, the answer is that the probability is 0.
There are approximately 250 nails to a roofing coil. When you buy them in a case they typically have around 7200 nails total. Hope that helps!
you should be using a roofing nail with a larger head to hold the shingle down more securely, staples are not used anymore and are not code..
Because it is flexible and easy to nail through.
The only type of nail for shingles is a roofing nail. Other nails have too small of a head and will pull through. You can use staples in an air gun, but they tend to pull through also.
Most commonly, roofing nails - a nail with an over sized head and a relatively short shank.
The horse is out of the barn at that point. You need to stop the water from getting under your roofing material.
That would depend on the type (common, roofing, concrete) and their size as measured like a two penny (2d) nail and so on. For example 60d common nails are 10 to the pound and 2d roofing nails are 225 to the pound.
Roofing nails have large, flat heads to hold down shingles, andtypically have a rough, galvanized coating. Standard box nails have smaller heads that are also flat, and the sizes are specifiedby penny - 4-penny nails are small, like what might be used to put a birdhouse together, 16-penny nails are the big ones commonly used for framing walls, etc.
98677 General Liability Code (Roofing—Commercial or Residential Over Three Stories) Visit us for roofing services: Green Shield Roofing
roofing cement can be used during winter time but you want it to be soft for easy spreading so you might want to put some cement in a can and drop that can into a pot to surround it with hot water to keep it soft until you dab it over the nail heads-- for now you can use a 2 inch scraper to apply a gernerous amount on each nail head that is leaking and in the Springtime or Summertime you can go up there and take a more thorough approach.