Want this question answered?
low gear oil or gears are worn.
To put oil in a gear box of a Chrysler PT Cruiser, first plug minor coolant leaks.
remove plastic nut on top of gear box and fill,, 2 litres of oil,,
It means that more gear oil is put into the gear box in order to have it at the right level.
sae 40, api cf
1.75l
it is at the left hand side of the engine and then you just put in
you can try wynns gear leak stop-it thickens oil and swells the seals.
you put 1400cc of gear oil into the gear box do no trust the fill level screw as the amount of oil was changed under production and you would not have enough oil in it then hope nthis helps you good luck
you remove insulator wearing cloves and put it in and connect it to the blue cabel
You put it from the the Bottom and wait three seconds and then drive for 2 miles and stop for 5 mins. After That, Unsrew it and see if it spills out. If it Does, go to your garage. If it does not, Srew it back and go round the block (to warm the oil), then use the horn for 0.5 second and Job Done!Garage in Cumnor, North Wales
the only place you put gear oil is in the rear end. Look on the differential and on the back there is a large nut, remove it to put in the CORRECT gear oil.