check by the exhaust pipe or catalyst
The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.
On a 1999 Camaro, the map sensor is located on the back of the intake manifold. The intake manifold is the series of tubing that distributes the air coming into the engine.
look under the throttle body on the front of the engine there s a sensor with 3 wires going to it that is the engine coolant temperature sensor
I would suspect the map sensor is bad.
The MAP sensor on an '86 Camaro with a 2.8 liter engine is located by the distributor at the rear of the intake plenum. There will be a black plastic casing that needs removed to gain access to the sensor.
The thermostat for a 1999 Chevy Camaro V6 engine can be found under the hood. It is in the right side of the engine, under the throttle sensor.
no, but it is mounted on the hose from the air cleaner to the the engine.
It is on the bottom side/ passenger side of the engine block, just in front of the starter.
On the side of the water pump housing
ithe 2.8 liter engine uses a mass air sensor to control fuel delivery. it does not have a map sensor.
There is not a separate cooling fan sensor, it controlled by the ECM which get it's reading from the ECT (engine coolant temp sensor)
the coolant temp sensor on an iroc-z camaro assuming your engine is stock is located below and a little to the left of the maf (mass air flow sensor). it should be pointing down and threaded into the top of the water pump hope this helps.