It's usually called the "oil filter adapter" since it provides a nice sealing surface and sometimes a better location for the filter.
Take off the oil nut and oil filter and drain old oil into a pan, then put nut back on and replace filter. Put in the right amount of oil your car takes through the filler under the hood.
A funnel
remove the oil cap on the top right of the engine. remove the oil plug from the oil pan underneath the car and drain the oil into container. Next remove the oil filter. The oil filter is on the left side if u are facing the car, covered by a plastic cover. Remove the oil filter and put a lining of oil on the gasket of the new filter. replace old filter and oil plug then put in 5 quarts of 5w30 motor oil. fin.
put the car on ramps put something to catch the oil under the oil pan open the hood remove the oil cap on the top of the engine unscrew the oil pan boly let it drain then remove the oil filter then once the engine has no oil put the oil pan bolt back in lube the oil filter seal put the new oil filter on and pour the oil in then turn the car on for a second to let the oil run through turn it off then check your oil level and your good to go.
the same way you would on any other car. there is a drain plug on the bottem of the oil pan you take that bolt out and let the oil drain and then you take the oil filter off . and make sure after all the oil is all drained out you put the plug back in the oil pan. replace the oil filter and put it back on and put oil back in the car
One reason why oil will drain out of a car after filling it up could be a hole in an oil filter. The car will need to be fixed before being driven.
No, not on a normal air filter. But if it is an oil filter yes you apply oil to the filter.
To change the oil filter in a Citreon Berling 1.6 hdi first located the oil plug under the vehicle. Put a pan under the oil plug to catch any oil that will drip down. Unscrew the oil plug. Let the oil drip out. Then gently unwind the oil filter from it's position and remove. Screw a new oil filter in this position. Replace the oil plug on the bottom of the car. Now put the requirement amount of car back into the car. Once the new oil has been added the vehicle is ready to drive.
first drive your car around the block to warm the oil then drive up on car ramps slide underneath the car you will see the drain pan with a head of a bolt sticking out loosen that up and take it out the oil will drain then remove your oil filter fill the new oil filter with oil put a dab around the ring of the oil filter then screw it back on put 4 quarts of oil in the car start it drive it down the ramps shut it off let it sit for 10 minutes check the oil level top it off if neccessary and your done
When changing the oil filter or the oil of any car, it is important to know how much engine oil to put back into the car. For this specific vehicle, the oil capacity is 4.5 to 5 quarts.
Put the front of the car up on ramps or jack stands - this lets you get under the car to access the oil filter. Jacking the rear of the car up level with the front helps the oil in the filter drain without getting all over the frame and axle, but it's still a mess when the oil trapped in the filter lets go. Optionally, you can jack up the right front, remove the wheel, remove the plastic fender liner and access the oil filter that way.
the oil plug is located under the drivers side,remove and drain the oil then remove the oil filter right next to the oil plug then put a little bit of oil on the oil filter gasget with your finger,then put on the filter ,put the plug back and put in the oil 5 quarts.