its on the passenger side engine manifold towards the collertor. its a one wire unheated connection. the wire my break out of the sensor so be careful.
The crankshaft position sensor for the 1995 Monte Carlo is located on the front of the engine. It is just to the right of where the crankshaft comes out of the engine.
where is the mass air flow sensor located on a 2001 chev Monte Carlo
The knock sensor is located on the front (radiator) side of the engine block above the oil filter The knock sensor is located on the front (radiator) side of the engine block above the oil filter
The speed sensor on a 1984 Monte Carlo is located on the output shaft. The speed sensor is typically driven by the gear of the vehicle.
in the exhaust pipe between the engine and the cat
Depends on the engine. On the 3.1 and 3.4 it is located on the front of the engine, up top, but below the power steering reservoir. The connector for the sensor is located behind the alternator. On the 3800 it is located in the front cover above the crank balancer pulley.
It is located in the transmission.
The Vehicle Speed Sensor is located on the transmission.jd
The Manifold Absolute Pressure (MAP) sensor is located on the firewall side of the upper intake manifold plenum
It is located on the transmission.
The fan relay will be located in the PDB box in the engine compartment. The relay is controlled by the coolant temp sensor and the computer. Hope this helps.
Under the thermostat