0
Which CPU socket makes use of a set of screw to lock the CPU into place?
Wiki User
∙ 14y ago
the VLIF socket is used to make use of the set screw to lock the CPU into place.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is a VLIF socket?
A VLIF socket is a componet used to lock and hold the computers CPU in place by using a set screw to do this.
What is a VLIF?
A VLIF socket is a componet used to lock and hold the computers CPU in place by using a set screw to do this.
Why have you got no heat in your rover 200?
I suspect an air lock in the coolong system. The bleed screw is located on the pipe running just above the gearbox, It's an 8mm socket that fits the bleed screw.
How do you replace brake lights in 1994 Nissan 300zx?
Remove brake light interior trim panels. Then you push and twist the socket for the brake light that needs replacing. Then pull out socket. then pull out bulb from socket and place new bulb in the light socket. Once bulb is installed into light socket. Place the socket where you removed it from brake light housing. Push and twist clockwise to lock back in place. Then replace trim panels.
How do you remove the trunk lock of a 1971 Pontiac Ventura?
You have to open the trunk lid, under the lock on the inside you will find a screw, remove the screw and the lock retaining clip, pull the lock out. If you can not open the trunk lid, drill the lock center out, and you should be able to open with a screw driver.
Is there a lock to keep 110 volt cords in place?
Yes, there is a cage that goes around the cord cap. This cage has a screw that is used to screw into the hole that holds the plate cover on. The cord can not be unplugged unless the screw is removed from the retaining position.
What type of a simple machine is a lock?
screw
How do you remove the ignition lock cylinder on a 1973 Firebird?
pull steering wheel off, remove the steering lock disc, then remove the signal light switch assembly to gain access to the retaining screw that holds the lock cylinder in place,
How do you remove ignition switch from steering column on 84 Pontiac fiero?
you have to remove the steering wheel then using a lock plate removal tool depress the lock plate and removed the clip that holds it in place then remove the lock plate then remove the screws from the turn signal switch and pull it up slightly then remove the screw that hold the lock cylinder in place then remove the lock assembly
What does the tire lock tool look like?
looks like a socket with a special pattern of the lock
Function of screw lock in Bunsen burner?
The screw is to change between a luminous flame(orange) and non-luminous flame(blue). You should always screw the lock so that it covers the hole first.
What size socket to remove wheel lock on car?
3.5mm
