0
Which circuit protection device is normally found in the engine compartment near the battery?
Wiki User
∙ 7y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the difference between a double and single circuit circulation?
a single circuit has only one source of energy, like a battery compartment (no matter the amount of batteries) a double circuit has two sources of energy, like two batter compartments
What is the purpose of the battery in the circuit?
The purpose of the battery in a circuit is to wive energy to the circuit
What jobs dose a battery do in the circuit?
The purpose of the battery in a circuit is to wive energy to the circuit
What is the function of the spring in the torchlight?
If you're talking about the large spring inside the battery compartment - it's to hold the batteries securely against the contacts that form the circuit.
Can a varistor be used as a circuit protection device?
No, a circuit protection device must open the circuit on a fault current or overload.
What does the positive side of the battery do?
When connected to the cable which normally runs to the starter it completes the circuit. Electrons flow from the negative terminal to the positive terminal.
What effect can be experienced by placing a 15a fuse in a slot rated for 5a on an electrical circuit?
For a circuit that is operating normally, it will continue to operate normally. However, by replacing the correct fuse with one of a higher rating, you are removing the circuit's overcurrent protection and, in the event of a fault, the conductors and load may become damaged. Incidentally, the symbol for ampere is 'A', not 'a'.
If you have a circuit consisting of a battery and a wire What two factors determine the amount of current in the circuit?
The voltage of the battery, and the resistance of the circuit (including the resistance of the wire and the internal resistance of the battery).
What job does the battery in a circuit?
To provide power for the circuit.
Why does a circuit stop working when you remove the battery?
The battery is the power source of the circuit. It supplies current to the circuit and the circuit is simply a path for the current to follow. When you remove the current (battery), the path still exists but there is no current going through it.
What is PDB in electrical engineering?
PDB could stand for power distribution board, normally a low voltage (below 1000V) board used in industrial applications. Typically contains about 20 circuit feeds, each one will have a fuse or a Miniature Circuit Breaker for overcurrent protection of the circuit it feeds. Normally fed in the UK by a 3 phase 415V supply.
What is the purpose of the batteries in the circuit?
The purpose of the battery in a circuit is to wive energy to the circuit
