answersLogoWhite

0

you can use

SHOW IP PROTOCOL

you will be able to see all running protocols in your router and its details...

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Which command displays the commands used to configure the routing protocol on this router?

The command used to display the commands that configure the routing protocol on a router is show running-config. This command provides a comprehensive view of the current configuration, including any routing protocols like OSPF, EIGRP, or BGP. To focus specifically on routing protocols, you can also use show ip protocols, which summarizes the active routing protocols and their settings.


Which command correctly starts routing process in cisco router?

To start the routing process on a Cisco router, you typically enter the command router [routing_protocol] in global configuration mode, where [routing_protocol] could be protocols like rip, ospf, or eigrp. For example, to start the OSPF routing process, you would use the command router ospf [process_id], where [process_id] is a unique identifier for the OSPF process. This command enables the routing protocol and allows for configuration of related settings.


Which command or set of commands will stop an RIP routing process?

To stop an RIP routing process on a Cisco router, you can use the command no router rip in global configuration mode. This command removes the RIP configuration and stops the RIP routing process from running. Alternatively, you can use shutdown within the RIP routing configuration mode to disable RIP without removing its configuration.


Which command will determine whether auto-summarization is in effect for RIP?

To determine whether auto-summarization is in effect for Routing Information Protocol (RIP), you can use the command show ip protocols. This command will display the routing protocol settings and indicate whether auto-summarization is enabled or disabled. Look for the line that specifies "auto-summary" in the output. If it is present, auto-summarization is enabled; if not, it is disabled.


What does the passive command provide to dynamic routing protocols?

Perhaps you mean the "passive-interface" command in Cisco routers; what this does is that no information related to the routing protocol will be sent through the specified interface. For example, the interface that connects your network to the ISP should not carry any routing protocol information, since the routing protocol is only useful within your company's network.


What is routing in networks?

This is when network routes are manually entered into a router's configuration, as opposed to using a routing protocol to automatically determine routes.


How do you stop rip routing updates?

To stop RIP (Routing Information Protocol) routing updates, you can use the "passive-interface" command on routers to prevent the interface from sending RIP updates. This command can be applied to specific interfaces using the router configuration mode. Additionally, you can disable RIP entirely by removing the RIP configuration from the router or using the "no router rip" command. Finally, implementing route filtering with access control lists (ACLs) can also help control the propagation of RIP updates.


What is static routing in networking?

This is when network routes are manually entered into a router's configuration, as opposed to using a routing protocol to automatically determine routes.


What are the fuctions of the network command?

it start the routing protocol on interfaces. it allows the router to advertise a network.


What is the process of sending routes from one routing protocol to another routing protocol?

The process of sending routes from one routing protocol to another is known as route redistribution. This involves configuring a router to accept routes learned from one routing protocol (such as OSPF or EIGRP) and advertise them into another routing protocol. To do this, network administrators typically use redistribution commands in the router's configuration, specifying the source and target protocols. Care must be taken to manage metrics and prevent routing loops during this process.


Which command allows you to review the status of configured IP routing protocols on a device?

show ip protocol


What protocol is RIP?

RIP stands for routing information protocol. It is an intra domain routing protocol.