0
What else can I help you with?
How is the router ID for an OSPFv3 router determined?
In OSPFv3, the router ID is determined by selecting the highest IP address assigned to an active interface on the router. If no interfaces are available, OSPFv3 will use the highest IPv4 address among the router's loopback interfaces, if configured. If no loopback interfaces are present, and no active IP addresses are available, the router ID remains undefined until one is assigned or the router is restarted. The router ID is essential for uniquely identifying the OSPFv3 router within an OSPF network.
Router have a mac id on its interface yes or no?
it should be on back of router!
What comment are use to delete a routing protocols in cisco router?
No router eigrp <AS #> No router ospf <process ID> No router bgp <AS #> No router rip
What is true about the router ID in a single area OSPF network?
The router ID is used to uniquely identify each router in the OSPF routing domain.If no loopback interfaces are configured, the router chooses the highest active IP address of any of its physical interfaces.
What is normally entered manually into a router?
area id
In what three ways can you configure a router?
What is the network ID of 199.255.255.9?
When was Orchard - RTD - created?
Orchard - RTD - was created in 2006.
When was Englewood - RTD - created?
Englewood - RTD - was created in 2000.
When was Belleview - RTD - created?
Belleview - RTD - was created in 2006.
When was Alameda - RTD - created?
Alameda - RTD - was created in 1994.
When was Yale - RTD - created?
Yale - RTD - was created in 2006.
When was County Line - RTD - created?
County Line - RTD - was created in 2006.
