Want this question answered?
link-local address
To configure a GRE tunnel, create a tunnel interface by issuing the interface tunnel command from the global configuration mode. To configure the tunnel source and destination, issue the tunnel source {ip-address | interface-type} andtunnel destination {host-name | ip-address} commands under the interface configuration mode for the tunnel.
The exit interface configuration consumes less router processing time
The exit interface configuration consumes less router processing time.
Ethernet
All interfaces in the same classful network as the configured address will be included in the RIPv1 routing process.
Just set the computer's IP Configuration settings to dynamic. That's it. Dynamic means that the IP Address is obtained automatically from a DHCP server.
the highest IP address of any logical interfacethe highest IP address of any physical interface
I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration
If a switch is connected to a router then the MAC address of the router is known to the switch through that port. A host takes advantage of this by using the default gateway address (the address of the router) which the switch "knows" by its lookup table. Therefore, the switch can learn the address automatically and no configuration is necessary.
Assuming you're not using DHCP (in which case it would be set automatically), you would use:ifconfig eth0 10.10.0.1substituting the correct interface card and IP address, of course.
There are commands in command line interface for this . To know the ip address of host you can use Ipconfig command . Ipconfig command will also gives your other details as well.