0
What else can I help you with?
Which three commands will change the current configuration mode of a router?
router ripline vty 0 4interface fastethernet 0/1
What can be concluded from the output of the running configuration of a router?
The commands that are displayed determine the current operation of the router.
Which commands will change the current configuration mode of router?
#Configure terminal for configuration mode #exit for previous mode #ctrl+z for set up mode
What commands will change the current configuration mode of a router?
1) #Configure terminal for configuration mode 2) #exit for previous mode 3) #ctrl+z for set up mode
What three commands will change the current configuration mode of a router?
1) #Configure terminal for configuration mode 2) #exit for previous mode 3) #ctrl+z for set up mode
What are some commands that can be used to verify router interface configuration?
plague
In a Cisco router when do changes made to the running-configuration take effect?
as the commands are entered
On a router which actions can be performed in user mode?
view current router configuration
Which mode enables you to view and change the configuration of a Cisco router?
Global Configuration Mode.
If a router is booting with its default configuration register setting and its NV RAM lacks boot system commands from where will the router try to load the IOS image first?
Flash memory
Starting at the enable mode prompt what commands would you type to configure IP address 192.168.1.1 on interface E0?
I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#
What is the router prompt for the user EXEC mode?
The router prompt for the user EXEC mode typically displays the device's hostname followed by a greater-than sign (">"). For example, if the hostname of the router is "Router1," the prompt would appear as "Router1>". In this mode, users can execute basic commands and view system information but do not have access to configuration commands.
