A cam shaft generally open and closes the valves. This is a driven component by a belt or chain to the crank shaft.
Camshafts can be driven by a timing belt, timing chain, or gear mechanism. These mechanisms transfer power from the engine's crankshaft to the camshaft to control the opening and closing of the engine's valves.
push rods connected to the camshaft
because your thermostat is opening and closing as the engine temp. fluctuates
An idle air control valve controls the engine idle revolutions by opening/closing to let more/less air into the throttle body (carburetor)-the car computer reads and controls the valve.
because one of the valves arnt closing or opening properly
The engine valve's primary purpose is to control the flow of air and fuel into the combustion chamber and the exhaust gases out of it. By opening and closing at precise times during the engine's cycle, valves ensure optimal performance, efficiency, and emissions control. They help maintain the right pressure and timing for combustion, which is crucial for engine power and efficiency. Proper functioning of the valves is essential for the overall health and performance of the engine.
The camshaft is typically located in the engine, either in the cylinder head (overhead camshaft) or in the engine block (cam-in-block configuration). Its primary function is to control the timing of the opening and closing of the engine's intake and exhaust valves. In modern engines, camshafts are often driven by a timing belt or chain connected to the crankshaft.
The Variable Camshaft Timing (VCT) cam sensor monitors the position of the camshaft in relation to the crankshaft in an engine. This information is crucial for the engine control unit (ECU) to optimize timing for valve opening and closing, enhancing performance, fuel efficiency, and emissions control. By adjusting the timing based on various conditions, the VCT system helps improve engine responsiveness and overall efficiency.
governor senses the speed of spindle of engine and controls the mechanism of opening and closing of throttle valve
Oil is drained by placing a container underneath the engine and opening the drain plug in the oil pan. Opening it slowly will allow you to control the flow.
A cam shaft generally open and closes the valves. This is a driven component by a belt or chain to the crank shaft.
The camshaft is typically located within the engine, either in the cylinder head (overhead camshafts) or in the engine block (overhead valve configurations). Its primary function is to control the opening and closing of the engine's intake and exhaust valves in sync with the pistons' movements. The precise location can vary depending on the engine design, such as whether it is a single overhead cam (SOHC) or a double overhead cam (DOHC) configuration.