In a virtual circuit network, there is an end-to-end connection in the sense that each router along the path must maintain state for the connection; hence the terminology connection service. In a connection-oriented transport service over a connectionless network layer, such as TCP over IP, the end systems maintain connection state, but the routers have no notion of any connections; hence the terminology connection-oriented service.
The last bit is called the stop bit. The entire sequence of bits sent over a serial connection can be found here: http://cnx.org/content/m12293/latest/
An isochronous connection is a path between two devices over a predetermined list of wireless channels. Bluetooth uses this type of connection to deter the amount of interference received as well as created. The basic idea of this connection type is that two devices will cycle between channels a-f, and repeat.
DSL (Digital Subscriber Line) Technology provided by Telecom operators enables high speed internet connections over Telephone Lines.
This phrase is used when obtaining orthographic views. It is common for one type of line to overlap another. For instance, a continuous line might be in the same location as a hidden line. For this reason, there is an order of precedence in terms of drawing conventions and standards. Typically the continuous line will have greater value or will "take precedence" over the hidden line, while the hidden line will take precedence over the centerline.
Cable TV connections (CATV)
Cable TV connections (CATV)
no need of telephone line for LAN networking. for LAN we ethernet card and other networking devices like hub, switch. for internet connection u need telephone line A Lan is a shared network of multiple systems. You can have a LAN which does not have Internet access and only supports Print/File Sharing. You need one router to assign IP addresses using DHCP and if more connection are required, just add switches. To give the LAN Internet access, you need an ISP connection and a modem. The existing router then connects to the modem. The ISP connection (today 2008) can be DSL, FiOS (over a phone line) or Cable. A dial-up connection can be shared on a LAN, but today that is a very poor choice and would not be connected as described above.
reflection
It is called uniform motion in a straight line.
In the twisted pair cable connection, the communication occurs over wires which offer resistance that make the connection slow. However, the fiber optic connection uses cylindrical glass that does not have any resistance making it the fastest connection channel.
work is done, it results in an acceleration along the line of the force.
Yes it is possible but expect when someone your phone you will disconnected from the line.
The freon MUST be removed first. You slip the tool over the line where you can see an opening with a spring inside. The small end if the tool towards the connection. Push the tool in to the opening and pull the connection apart. There is more than one type of this tool. Some of the tools just slip over one part of the line and the other style goes over the entire connection. I have both and prefer the first one because I find it easier when I can see what I am doing.
You need a fuel line disconnect tool. Slide it over fuel line and push towards the connection and pull, the line will come off.
Weather occurs over a small area. Climate occurs over a whole region.
DATA Transmission is done through SLIP (Serial Line Internet Protocol) & PPP (Point to Point Protocol) Protocols to enable computers to interact with Internet over Telephone Line.