0
Which device contains high current contacts that connect the battery to the cranking mortor?
Wiki User
∙ 8y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Caution do not connect improperly charge or dispose of in fire battery may explode or leak what is this message?
Anything that carries that message contains a batterythat can explode or leak if you try to charge the battery, if you connect the battery to something else, or if you throw it into the fire.
Ford truck 83 f100 sometimes it will start and run fine other times it will not stop cranking unless you remove battery cable but when you connect cable back it cranks as soon as it touches battery?
Either the solenoid or starter has gone bad.
How do you transfer your contacts from your Outlook to your iPad?
You connect it to itunes and go to the contacts bar and sync outlook contacts
A computer motherboard contains or openings with multiple electrical contacts that allow devices such as nics modems or sound catrds to connect to the computers expanded bus?
expansion slots
Which battery post do you connect first when replacing a car battery?
You connect the positive terminal first.
How do you install battery in Suzuki GS500?
remove the seat, place the battery into the holder, connect the drip tube, connect the battery connectors
How do you replace positive battery cable on 1997 Ford F150?
Remove - battery cable Remove + battery cable from battery and starter solenoid Route new cable following original routing Connect to starter solenoid Connect to + battery terminal Connect - battery cable
How do you hook back up a car battery?
Connect the Positive + battery cable to the positive + battery post first. Then connect the Negative - cable to the negative - battery post.
I just replaced the starter in my 81 gmc short box with a 350 cc engine and when i attempted to connect the battery cables it would start cranking over trying to start why would this happen?
There are two SMALL wires on the starter. They are connected wrong.
How do you connect the battery to the coil to start a honda cd175 engine out of the frame and on the bench?
Just connect the battery to the motorcycle battery cables with jumper cables and then start it.
How do you make a diagram of a battery and a bell?
Use the symbols for a battery, switch and bell and connect them together with a line starting at one side of the battery. From the battery series connect the switch and bell and then a line back to the battery.
When you charge a battery do you connect positive or negative first?
The man said it Always connect the positive + cable first to the battery. Then connect the negative- cable to the engine somewhere. Never connect the negative cable to the battery itself. Batteries vent hydrogen gas and which can ignite with the slightest spark. For this reason never, ever, connect the negative first and never connect the negative to the battery.
