Auto Parts and Repairs
Ford Explorer

Which fuse controls the inside lights on a 1993 Ford Explorer?

505152

Top Answer
User Avatar
Anonymous
2020-04-04 23:09:42
2020-04-04 23:09:42

For 1998 ford explorer

12
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

User Avatar
Wiki User
2007-03-05 19:34:24
2007-03-05 19:34:24

Check ALL fuses. If you want to take the fuse for the lights out, just start pulling fuses until it goes out. There may be more than just those lights on that fuse.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Where is the fuse located that controls the inside dash lights on a 1993 Ford Explorer

User Avatar

there is a brake light fuse in the pannel you just need to look for it.

User Avatar

Inside the door.. usually held on by large rivets.

User Avatar

The electric fuel pump is inside the fuel tank

User Avatar

There is a fuse replacement to get the dash lights to work on a 1993 Seville. The fuse for the instrument panel is located in the fuse box inside the passenger side of the trunk.

User Avatar

The 1993 Ford Explorer fuel gauge fuse can be found in the fuse box. The fuse box can be found in the engine compartment. The location of the fuse is listed on the inside cover of the fuse box.

User Avatar

A 1993 Ford Explorer has shock absorbers , front and rear

User Avatar

The Northwest Explorer was created in 1993.

User Avatar

The PCU is inside the console up towards the front directly below the heater/AC controls.

User Avatar

your bulbs are burnt out. when you switch on the high beams its only the high beams. but when you flash your brights it lights up both high and low beams.

User Avatar

How do you disable the Anti-Theft light in the 1993 ford explorer

User Avatar

The interior lights can be turned on (and brightened/dimmed) by rotating the knob you pull out to turn on the exterior lights. To turn them on, turn it to the right.

User Avatar

haynes repair manual for 1993 Ford Explorer Eddie Bauer

User Avatar

I believe the 1993 Ford Explorer ( 4 door ) is 19.3 U.S. gallons

User Avatar

The brake lights and all of the rear lights can be access through the inside back molding in the rear. there are little knobs that you turn to access them.

User Avatar

i'm pretty sure that nearly ALL the FUSES are now inside ....next to the heater controls

User Avatar

I believe on the 1993 / 1994 Ford Explorer it is mounted low on the firewall near the drivers side fender

User Avatar

The 1993 Ford Explorer is designed to use " regular " unleaded , 87 octane

User Avatar

According to my Haynes Ford Explorer repair manual : ( MERCON automatic transmission fluid is used in the transfer case of a 1993 Ford Explorer )

User Avatar

1993 jaguar xj6 Tail lights turn on and off

User Avatar

How do you turn on dash lights 1993 mercury grand marquis

User Avatar

On the inside of the fender just behind the battery. It has two cables attached to lugs, and a small wire at the bottom that is pressed on to a stud.

User Avatar

A 1993 Ford Explorer takes 5 quarts of oil for a complete oil and filter change.

User Avatar

How would i repair a 1993 ford explorer 4.0 liter A4LD Transmission?


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.