in the fuse panel both turn signals are operated on one fuse. the flasher unit makes it flash.
trouble putting right front signal bulb in.
pivture to change right turn signal
you have a blown bulb, some vehicles use a double filiment bulb that operates the turn signal and brake light
It has been my experience that a rapid turn signal indicates there is a burnt-out signal light bulb (either front or rear) on the side of the rapid blinking signal. If the right signal is blinking rapidly, the problem is in the signal lights for the right side (front or rear) of the vehicle. Turn the rapid signal on and step out of the vehicle to find which bulb is not lighting.
More than likely you have a burnt out bulb at the front signal light, rear signal light, or brake light on the right side.
you have to go inside engine compartment to the front right side,then reach in and disconnect signal/parking bulb holder electrical connector.Then rotate the turn signal bulb holder 1/4 turn COUNTERCLOCKWISE to remove it.
NO
reach up under front bumper and twist the bulb out.
One of the front blinker bulbs is burnt out. Replace the bad bulb and the blink should function normaly. you have a front right turn signal bulb that is burned out. the resone it blinks fast is there is less load on the flasher .
Check the fuse for the wipers and replace the turn signal bulb.
700$ depending where u go.
Because the signal system is interconnected.Install new bulbs on the left side -including the front side...I realizethey work. You will be surprised.