The red connector is positive +.
Connect the positive clip of the charger onto the positive post of the dead battery. If the battery is located inside of a vehicle, connect the positive charger clip to a grounded surface--like an engine block--on the vehicle.
You connect the cables BEFORE you plug in or turn on the charger. Positive (red) to battery positive first, then negative (black) to battery ground. Then you turn on your charger and set the timer.
Yes you can. Connect the chargers positive lead to the positive of one battery, then the negative side of that battery to the positive side of the other battery, then connect the negative lead of the charger to the negative of the second battery. Double check all your connections and turn on the charger.
Connect a battery charger to battery positive to positive negative to negative
First connect the battery charger positive connection to the Positive post on the battery and the negative connection to any place on the engine away from the battery and not on the negative battery post. Connecting the battery charger any other way is unsafe.
A charger is hooked to a 98 Monte Carlo battery by attaching the positive lead to the positive battery post and the negative lead to a strong ground. The charger is set to the desired rate and plugged in.
Yes, just find connect the charger positive cable to the positive + side post terminal on the battery. Then connect the negative charger cable to any metal place on the engine. Plug the charger in and it will recharge the battery.
Connect the positive (+) Red cable from the charger to the positive (+) post of the battery. Now connect the negative (-) Black cable to a metal part of the engine. Do not connect to negative battery post. Plug the charger in. Unplug the charger before removing the cables. Disconnect the negative cable first.
depends if the battery does not have at least 4 volts in it then ,you will have to find an old time charger Chargers of today have to have a 4 volt signal from the battery being charged to the charger to turn on. You can trick it by putting a battery with at least 4 volts in it and then hook the other battery to the one already hooked up . Hook them parallel charger positive to battery positive and batteryu positive to other battery positive neg same way You do not have to remove battery from car to charge it
It is normally red.
I can if I charge 2 of them at a time. Most 24 volt chargers also have a 12 volt setting. What is hard to find is a 32 volt charger. We can charge a 12V battery with 24V charger, by connecting two 12V batteries in series i. e. the negative terminal of the first battery is connected to the positive terminal of the second, now the charger positive terminal is connected to the first battery positive terminal and the negative terminal of the charger is connected to the negative terminal of the second battery.
Connect them together in Series. Connect the negative post of one battery to the positive post of the other battery. Then connect the negative charger cable to one negative battery post and the positive to the positive post of the other battery.