zinc, copper, silver, aluminum, alloys or metals that have low melting point
Copper is used in the contact points in fuse boxes because it will oxidize and you can separate the points of contact. If it was made if iron and rusted, it will 'weld' the link together and then it is no longer a fuse.
The material suitable for making a fuse wire should have a low melting pt. so that it can easily melt and cut off the flow of current and save the electrical appliance...
The fuse is made to blow at a set amperage to protect the wire from overheating. Using anything but the fuse may cause the circuit to work but could most certainly cause the wiring to overheat and burn if it is overloaded.
If a thick copper wire is used in a fuse then by definition of a fuse this device would no longer be defined as a fuse. A fuse in a circuit is used to protect the conductors feeding the load of that circuit. The circuit, if using a thick copper wire in a fuse, would then be considered as a non fused circuit.
So that the live wire is isolated when the fuse blows. If a fuse was placed in the neutral, the equipment would still be live when the fuse blows.
Copper is used in the contact points in fuse boxes because it will oxidize and you can separate the points of contact. If it was made if iron and rusted, it will 'weld' the link together and then it is no longer a fuse.
The material suitable for making a fuse wire should have a low melting pt. so that it can easily melt and cut off the flow of current and save the electrical appliance...
The material for the fuse wire should have low resistance and a low melting point. Ductility is a incidental factor. As the current flow nears the fuse rating, the high current flow causes the wire to heat up quickly. It then melts, opening (breaking) the circuit. This is how the fuse limits the amount of current that can flow through a circuit.
The fuse is made to blow at a set amperage to protect the wire from overheating. Using anything but the fuse may cause the circuit to work but could most certainly cause the wiring to overheat and burn if it is overloaded.
NO. Usually the positive wire will have the fuse.
Why is it dangerous to replace a fuse with a wire that bypasses the fuse
a material that can be stretched into a wire
The 15 amp fuse.
A circuit breaker does not have a wire fuse in it.
Fuse wire is designed to open under over current conditions. Just like a fuse.
If a thick copper wire is used in a fuse then by definition of a fuse this device would no longer be defined as a fuse. A fuse in a circuit is used to protect the conductors feeding the load of that circuit. The circuit, if using a thick copper wire in a fuse, would then be considered as a non fused circuit.
yes there is a fuse in the fuse box. the wire will lead to it or to the ignition switch. But the fuse to amke the hot wire hot is in the under dash mounted fuse box.