No. It seems Zinc would always act as the negative terminal. Anode and Cathode are the terms used when we connect an external electrical source to the device. If positive terminal of an external battery is connected to the electrode then that electrode is named as ANODE. If negative terminal is connected then it is named as CATHODE. In case of chargable device, while discharging say P acts as negative terminal. Then while charging this negative terminal would be the anode. So if the device is a chargable one and Zn acts as negative terminal while delivering current to the external load, then the same zn would acts as anode while charging.
Nothing
The negative battery terminal is on the battery. They don't have a wire coming from it like they do the positive. For charging purposes, the engine block acts as the battery ground. When disconnecting the negative at the battery, the negative terminal usually has a black wire and the positive has a red.
The negative terminal of a battery has a - sign and positive terminal has a + sign.
I think the negative terminal is under the fuse box to the left; you can barely get to it. However to jump from or to the Silhouette, you don't need the negative terminal. To jump the Silhouette, just attach the negative cable to metal, preferably of the engine block. To jump from the Silhouette, attach the negative cable to the large bolt about 10 inches to the right of the battery.
Anode is the negative terminal of a battery. It is made of Tungsten which is the same metal used in the filaments of bulbs.
If your talking about the main ground wire from the battery, its located on the metal wall right to the left of the negative terminal. Just follow the wire that comes off the negative terminal back six inches to a foot and you can see where the ground wire splits off and bolts to the metal.
Look for a + by the positive terminal and a - by the negative terminal, or red for positive, black for negative. Some batteries have the positive terminal protruding and the negative terminal flat. Or you can get a meter that will tell you which is which,
The negative terminal does not go to the starter on a negative ground system. The negative terminal goes to ground.
Any bare metal part on the chasis of the vehicle is used as the ground. Or the negative terminal on the battery.
No, you should remove the negative first. That way if your wrench slips and hits a metal part of the car and the battery at the same time it will not spark.No, you should remove the negative first. That way if your wrench slips and hits a metal part of the car and the battery at the same time it will not spark.
The negative terminal is called the anode